Results 1 to 10 of 118
Thread: New Matter updates
Threaded View
-
10-20-2015, 09:44 PM #35
- Join Date
- Dec 2013
- Location
- Georgia
- Posts
- 934
Well, I've finally finished out my free half-kilo of SUPER FREAKING PINK filament, unfortunately I wasn't paying attention at the end of the spool and I got to experience clearing out my first jam...
Long story short, it was a heck of a lot easier than with a Makerbot, the hot end unplugs from the head unit and simply unscrews (they even have an instructional video on youtube for it) after that it's a simple matter of plugging it back in, heating it back up while unscrewed and pushing the filament the rest of the way through (with proper protective gear, of course) The whole process took about 5 minutes.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion