Close



Results 1 to 6 of 6

Threaded View

  1. #1
    Technician
    Join Date
    Nov 2014
    Location
    New Orleans
    Posts
    50

    Question Why are my corners raising up? (on top of print, not lifting off bed)

    This seems to be a new issue since I have adopted slic3r 1.2.9. My corners are raising up significantly, and it gets progressively worse with round slopes (e.g. when printing a sphere). It looks like it is extruding too much in the corners, or not retracting enough maybe? I have attached some examples of a perimeter width test (the parts don't quite fit, but I think if I can solve the corner round/overextrusion they may be close).

    Edit: I am printing natural PLA at 200* with 60* bed temps and 15% infill with a part cooling fan running at 100% for the duration of the print.

    IMG_2920.jpgIMG_2921.jpg
    Last edited by dustmann; 10-20-2015 at 09:29 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •