Results 1 to 10 of 13
Thread: Raft settings?
Threaded View
-
10-10-2015, 03:19 PM #1
- Join Date
- Jan 2015
- Posts
- 445
Raft settings?
Good afternoon folks... So i havent ever printed with rafts before,but i think I have to start doing it. Even on PEI with a brim the part still peels in the corners . Its a fairly dense part about 3 inches x 10 inches, so fairly large too.
My first attempt at raft settings was 75% infill , .14mm from part, about 15mm out from the part
2nd one is running now at 50% infill and .2mm from the part.
Is the 2nd setting more likely to produce better results?
THe first one i could not detach from the part the top layer of the raft... like at all.
What do you guys typically use for settings? Im using S3d and a taz 5.
thanks
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion