Results 1 to 3 of 3
Threaded View
-
10-10-2015, 03:10 PM #1
- Join Date
- Oct 2015
- Posts
- 2
Makerbot Replicator - message: Homing Error
When starting a print (example), the printer sounds as fulfilling a job, but the table does not lift, and after some time it displays this message:
Homing Error - homing failed (Error 1032: Bad Hes Waveforms). Your extruder nozzle may be stuck, please try again.
As said the table is at the bottom and the filament was applied in the correct way. Any advice is welcome ;-) don
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion