Results 1 to 10 of 20
Threaded View
-
10-08-2015, 04:01 PM #11
But have you measured temp of the Motors while printing??
I have and they get way too hot without a fan blowing directly on them.
I certainly would Not want my Favorite motors hanging about in that Hostile Environment
of an enclosure !
Aqua-net is the Best !!!
Just the Correct amount of 'Holding Power' !Last edited by EagleSeven; 10-08-2015 at 04:10 PM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion