Results 1 to 10 of 54
Thread: bq's Ciclop 3D Scanner
Threaded View
-
10-08-2015, 03:41 PM #36
- Join Date
- Jul 2014
- Location
- UK
- Posts
- 124
So I bit the bullet and bought the fill kit.
Putting it together was straight forward enough and I seem to be getting fairly decent scans after a lot of tinkering but as owens-bill said above, getting a printable mesh is another story.
Is anyone else having any luck or has this thread gone quiet because of this stumbling block ?
Last edited by scobo; 10-08-2015 at 03:46 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion