Originally Posted by
PixelPusher
Since my last post above, I've had to replace a few electronic pieces as well as new rods and bearings. I'm not sure where you're buying from, but I strongly suggest going through a reputable outfit. I chose the "cheap" route buying from China and I'm paying for that mistake. I've invested about 8 hours building it, and 20 hours troubleshooting/calibrating, and I still have not had one successful print! I should have just bought a Taz5.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help