Results 1 to 10 of 10
Thread: Another Corner Curling Up Issue?
Threaded View
-
09-17-2015, 11:45 AM #4
- Join Date
- Jul 2015
- Posts
- 27
Looking around online I saw that 140 degrees Fahrenheit is an optimal tempature inside an enclosure when printing with ABS. That is ABS I'm printing with. I built the enclosure because I was having warping and layer adhesion issues on a large about 6" x 6" build. While running the temp inside the enclosure gets up around 110 max. I have a filament bulb in the back adding heat I can turn that off. Also the front and rear plexiglass pieces are removable so I will trying lowering the temp a bit when I get home today.
*EDIT** Hot end is at 250c and heated bed at 110c. The fan on the hot end fan is blowing from the front towards the backLast edited by CoffeeCup; 09-17-2015 at 02:23 PM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion