Subscribe to Our Newsletter Advertise
Close



Results 1 to 5 of 5

Threaded View

  1. 09-06-2015, 12:55 AM #1
    ziconeo
    ziconeo is offline
    Student
    Join Date
    Sep 2015
    Posts
    4

    Z axis invisable wall issue

    Hi everyone I'm new to this forum and I could really use some help.

    I have a prusia I3 made by sintron

    Ramps 1.4 board programmed with arduino firmware

    For some reason I cant print past 100mm along the z axis. I should be able to go to about 180, but it always just stops. I even put in larger printing perimeters into my slicers to no avail. any help would be awesome!

    Oh and can someone tell me how to view my current firmware installed on my ramps 1.4 so i can edit it?
    Last edited by ziconeo; 09-06-2015 at 01:01 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules