Results 1 to 10 of 32
Thread: Any Problem Contact Me
Threaded View
-
08-30-2015, 08:03 PM #11
- Join Date
- Jul 2015
- Location
- Calif.
- Posts
- 26
Hi Alfred,
I just started up the scanning software and started a scan, it went through the first scan on the turn table and then it crashes. I restarted the computer and started it again and it crashed. Up until now I have been scanning with out any real problems. I am using the last release of the software on win 8. I have not added any new programs as I was going to use this machine for only scanning.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion