Im new to 3D printing and have so far managed to solved my initial issue of a terrible first layer however now im having issues with my top layers looking terrible and ruining my prints.

See the picture bellow
Poor Top Layer.jpg

It seems by the time its doing the top layers the extruder is to low causing it to drag around the top layer messing it up however maybe its just to much filament has been used which really adds up by the time it gets to my top layers

How can I get a normal looking top layer?
Iv tried a range of temps (200c > 225c) and speeds (20 > 100) but I get a constant top layer result.

I have only been printing at .3 res with blue tape and heater bed off.

Im using ReplicatorG with a CTC 3D printer from China.

Iv managed a few nice prints however when there is flat top layers they look like the above.


Any thoughts??