Results 1 to 5 of 5
Threaded View
-
08-08-2015, 12:30 PM #1
- Join Date
- Aug 2015
- Posts
- 1
Trouble with printing model layer
Hello. Week ago I have bought a 3d printer (DIY kit of Zonestar P802YA). After spending 2 days assembling it and then even more trying to calibrate it I managed to get stuff that looks like proper model. But unfortunately layers have sections where filament thread is thinner and thus creating holes. I took some photos of two of my models:
Here are photos of 2 models of same g-code(1 finished and 1 stopped):
You can clearly see those defects I was talking about. Also honeycomb grid is very messy.
I use PLA filament 1.75 mm. Temperature 210-230C. Do not heat bed. Feedrate 80. Flowrate 50. On the unfinished I used FdRate - 65-70 and FlRate - 50-65. Which values should I adjust to fix this?
Here's Dropbox link to the model.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help