Results 1 to 7 of 7
Threaded View
-
08-03-2015, 11:31 PM #1
- Join Date
- Feb 2015
- Posts
- 371
Not your typical 3mm vs 1.75 question
I have read a ton of debate on this subject on what is better. I am still on the fence.
My question is in regards to the filament as is is wrapped on the spool. Towards the end off a spool, my 3mm filament is almost impossible to use. It is tightly formed to the spool that it puts a lot of strain on the itself and will pull the spool out of my holder without actually unrolling.
I am using a bench spool holder and the filament rolls on bearings. I also have a bearing filament guide on the top of the printer where the old spool holder went.
Does 1.75 filment get this stiff towards the end of the roll?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion