Results 1 to 7 of 7
Threaded View
-
08-03-2015, 11:31 PM #1
- Join Date
- Feb 2015
- Posts
- 371
Not your typical 3mm vs 1.75 question
I have read a ton of debate on this subject on what is better. I am still on the fence.
My question is in regards to the filament as is is wrapped on the spool. Towards the end off a spool, my 3mm filament is almost impossible to use. It is tightly formed to the spool that it puts a lot of strain on the itself and will pull the spool out of my holder without actually unrolling.
I am using a bench spool holder and the filament rolls on bearings. I also have a bearing filament guide on the top of the printer where the old spool holder went.
Does 1.75 filment get this stiff towards the end of the roll?
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help