Results 1 to 10 of 14
Threaded View
-
07-13-2015, 06:24 PM #12
It finished a while ago and upon inspection it is a bit better, i measured the diameter of the filament at it was 1.8mm so I put that into Slic3r settings. I used the red ABS from PrintME3D this time. I'l post pictures tomorrow (UK time) when its a bit better lighting.
I need to get some more filament but I am unsure whether to get ABS or PLA. I can't seem to get the PLA I have to print properly without it jamming up and making an awful clicking sound after about 2 minutes. Does anyone know how to fix this? It's a shame because I've heard PLA is "easier to print" and is more suitable for most applications but with my experience I just want to avoid it.
Finally, Are any brands better than others? I'm looking at getting some PrimaABS or PrimaPLA rather than PrintMe3D's filament although I can't decide for the life of me whether to get bright green, orange, yellow, blue or grey received_967774903265133.jpgLast edited by BradR97; 07-14-2015 at 04:48 AM. Reason: Added picture
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion