Results 1 to 10 of 28
Threaded View
-
02-06-2014, 01:50 PM #11
Well after 3 days of experimenting, I'm at my wits end with this filament. It prints nicely at the beginning of each print, but cannot do subsequent layers consistently. Sometimes it'll miss infills, miss sections in a layer etc. Tried everything, adjusting temps, high, low, nothing...flow rate...nothing...tightening the idler since filament might've been slipping...nothing...used different versions of Slic3r...nothing. You name it, I've tried it...LOL... I'm beginning to feel this filament is not a consistent quality. After losing 3 days of print/work time, I think it's time to contact the producer and ask for a refund. Such a shame.
I've since reinstalled my MakerFarm filament and it's printing fantastic again.
I'm not bashing PushPlastic one bit, maybe I got a bad batch, I don't know, but I feel like I've spent enough time now with the filament to know it's not for me.Last edited by MeoWorks; 02-06-2014 at 01:59 PM.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help