Results 1 to 10 of 18
Thread: Simplify3D settings?
Threaded View
-
06-23-2015, 08:39 PM #16
- Join Date
- Jan 2015
- Posts
- 306
You could also fudge your print by putting a 0.4mm nozzle, leave that alone, and boost your flow to something like 175% and it will lay down a very wide single layer. This will be tricky with ABS since the W/T ratio is high if you do that, and that may cause a lot of internal stress. I sometimes go this route.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help