Results 1 to 4 of 4
Thread: I'm Really Confused
Threaded View
-
06-16-2015, 10:39 AM #1
- Join Date
- May 2015
- Posts
- 14
I'm Really Confused
I have a 3D printer that I want to install a new electronics package in. I decided to go with the Rambo 1.3 board. This board says it can use 12 or 24 volts. My questions are: What voltage should I run? What power supply is recommended? And what motors will work with this? There are many different options that are specified to different voltages and I am unsure about what motor to run. I think 12v should be enough because I am not adding a heated bed (LDM). Does this mean I need motors that are rated to 12v?
I was going to buy this board:
https://ultimachine.com/content/rambo-13
With these motors:
https://ultimachine.com/content/kysa...-stepper-motor
Will this work?
-Nick
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help