Results 1 to 10 of 20
Threaded View
-
06-15-2015, 12:03 PM #1
- Join Date
- Jun 2015
- Location
- Stoughton WI
- Posts
- 6
FlashForge Creator Pro, can get filament to stick to table
Hey all,
Total newb here. I just bought a Flash Forge Creator Pro and am trying to run the 20mm calibration cube as a first part. I have been trying unsuccessfully for two days now to get a line to stick. I have gone to the control panel and pre heated it to 220 for filament and 115 for bed temps. I am running the ABS that came with the printer. I have calibrated the table with a sheet of paper as well. I just cannot get a line to stick to the table. I have tried Painters tape, but to no avail. ANY HELP IS GREATLY APPRECIATED!
Thanks!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help