Hello guys,
i have some problems with my Printer.

I have been printing PLA sucessfully on a glas surface with a slightly heated bed.
After that, i tried printing ABS, but it did not want to stick to the Bed. I tried hairspray, but still no adhesion. Then i ordered BuildTak.
Now, with BuildTak on my Printbed, i am unable to get the prints of my bed.
They stick so well, that i have to pry to get them off. I already damaged 2 BuildTak surfaces in that process. It is ridicuasly hard to get them off.

This problem exists with ABS as well as PLA.
Even if i just print a single layer, it is sometimes hard to get that off.

I have tried printing 0.3mm above the bed and turning of the heating (PLA), but that does not help at all.

So i either use just the glass surface, where ABS does not stick at all or i use BuildTak, where i ruin my prints, when i try to pry them off.

Does anyone of you have an idea on how i could solve this?
Some Settings, that might lead to a "less stickier" print?

Thanks for any suggestion