Results 1 to 10 of 36
Thread: Build platform woes.
Threaded View
-
06-09-2015, 04:20 PM #2
- Join Date
- Jan 2014
- Posts
- 462
If you Z offset does not remain constant, does that not indicate that you're missing steps on the Z axis? You've implied that you have multiple printers - does it happen with all of them? You say the problem tends to happen after a purge - can you give more detail about the circumstance? I'm assuming this is a purge at the start of a print. Can you make bed levelling and Z offset part of your print setup procedure? Does your Z axis suffer from overheating? Have you tried fettling the vref? Are your Z motors wired in series or parallel? Is it an issue with one or both of the Z axis stepper?
Sorry for all the questions, but it's an issue with many possible causes.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion