Results 1 to 10 of 30
Threaded View
-
06-02-2015, 02:58 AM #21
You're right to a point but as you try to get smaller and smaller Z-steps you'll run into issues with the meniscus. There were some ideas around raising and lowering the level (like up 3 drips, down 2 drips) before the laser does its thing but I don't think this is a stock feature of the peachy.
In fact, I'd be interested to know if any special printing methods were used for that rook. Maybe Rylan will tell us...
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion