Results 1 to 10 of 16
Threaded View
-
05-31-2015, 10:26 AM #1
Bottom corners curl up during printing (warping?) SOLVED
Hello,
I use the Ultimaker2 which has a heated glass plate at 60 degrees celsius (140 Fahrenheit) as standard setting. As you can see in the image the bottom corners curl up slightly despite the brim i use. Even the brim is pulled up by the object. The filament is PLA.
556b24282e838.JPG
As the object is on the plate for many hours, i think it shrinks like loundry that is overheated. So first question: how can i tell gcode to lower the temp of the glassplate after say 5mm. The object then is heavy enough by itself not to move around. And i can put some "glue" under the object to fixate it.
Or is there another reason why this happens?
Thanks.Last edited by jeex; 06-05-2015 at 04:35 AM.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery