Results 1 to 4 of 4
Threaded View
-
01-30-2014, 08:41 PM #1
Stuck a little - Raise before print, then lowering (Z Axis)
Hello again!
I'm stuck on something that is probably simple!
Printer goes home when it starts a print, it will then raise 5mm, but when it lowers again, I need it to drop 6mm.
My printer's bed and Z stop are hard to line up, I will work on it again soon enough, but currently I have to pause the print before it starts, lower Z by 1mil and then its golden!
Is there any way to make it lower 1mil extra?
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)