tryed so many different firmware setups and just getting fruststrted prusa i3 1.4 step arduni 2560 mks genv1.1

when home is pressed are the axis supposed to go to end switchs
if i home a axis it just moves a mm or 2 and stops does not go home
is about 10mm from bed when i try to print so just blobs everywhere and comes out fast
where would i get someone to explain what each step does in marlin
or the best setup as there sso many different ones
or anyone in derbyshire near burton upon trent who could help me out

please help had enough now also i have a lcd controller can i alter all things in this instead of marlin firmware
heres a video of what printer does when use in pronterface

old firmware upload
as new from github wont upload freezes on compile any ideas
also is replicater firmware an diffrenthttps://youtu.be/9S_JLNvni8w