Results 1 to 7 of 7
Threaded View
-
05-19-2015, 11:07 PM #7
- Join Date
- May 2015
- Posts
- 30
Hi 82cabby!
We had this issue with our z18 at first. No matter how many times we leveled the plate or reset it it would always hit the build plate. I ended up manually adjusting the z axis offset. Raise it all the way up and stop your print after the first raft layer. It will probably look very bubbly. Lower the offset one step at a time until the raft layer is smooth.An offset of .6 works best for us. Hope this helps. fyi I complained to support about this and they sent me a new plate and tape.Last edited by pa9k; 05-19-2015 at 11:08 PM. Reason: spelling errors
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help