Results 1 to 2 of 2
Threaded View
-
05-18-2015, 04:51 PM #1
MakerBot Replicator 2 fan duct hitting print
Hello, I am using a MakerBot Replicator 2. I am not exactly sure why this started happening, but on my last few prints once they start to get a bit of height, the bottom of the fan duct next to the extruder nozzle will ram into a corner of my print and knock the whole gantry back, ruining my entire print. I'm not that knowledgeable in this stuff, and don't really know what I did wrong. Here's a pic of the fan duct and nozzle.
Thank you in advance for your advice!
http://imgur.com/jzspKYW
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery