Results 1 to 10 of 85
Thread: Simplify3D with FlashForge
Threaded View
-
04-21-2015, 07:10 AM #29
- Join Date
- Dec 2014
- Posts
- 61
Yes, S3d does have ts faults, the chief one being lack of good doumentation. understandable for free stuff but unacceptable at $140.
It is my primary slicer though. As Mr. Aardvark says, Once you have it set up it stays setup. S3D support has been very helpful.
Sometimes I still use MW though for very simple prints, and for some iinvolved dual extruder prints because MW will automatically line up both files which is very time consuming manually.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion