Results 1 to 1 of 1
Thread: Possible sd card issue
Threaded View
-
04-20-2015, 07:33 AM #1
- Join Date
- Dec 2014
- Posts
- 1
Possible sd card issue
My creator x is stalling mid print when printing from the sd card. Running several test I have been able to complete the print using USB. When it stall all axis are enabled sometime the extrude seems to increase speed. I have had both the x and y axis randomly take off until physically being stopped. I am running sailfish 7.7 it worked in the past as this is a recent issue. My x axis sensor cable was replaced as it was going bad. I have also done the dual power mod. Any ideas? I have ordered a new sd reader hoping that's the issue.
Thanks for your help.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion