Results 1 to 3 of 3
Thread: Migbot i3 Prusa Y axis Issue
Threaded View
-
04-20-2015, 03:11 AM #1
- Join Date
- Apr 2015
- Posts
- 2
Migbot i3 Prusa Y axis Issue
So i bought a Migbot i3 Prusa from https://www.3dprintersonlinestore.co...t-prusa-i3-kit . And honestly it's better than i expected.Any issues aside from the one i'm about to talk about seem like human error and come and go (i'm new to 3d printing.But for some reason I'm having an issue with the y axis the prints turn out fine but they aren't starting in the right spot I have used both Cura and Repetier and both do it. Doesn't matter where i put the model it prints almost 2 inches forward of the position in the slicer. for small prints this is a non issue but if i want to take up 100mm or more of the y axis on my bed some of the print will hang over. and if i place a model at the front of the slicer it will just ooze plastic on the floor. I can't figure out what i am doing wrong.
6.jpg
nooby question,sorry
09-24-2024, 12:06 PM in General 3D Printing Discussion