Hi, I know there are tons of resources out there, I'm just hoping someone who knows the answer or has an idea can quickly point me in the right direction.

We've had some issues with the thermal tape coming off and resistor wires getting pinched on our print head.

All seems to be working, but when we try to print fine (0.1mm), we get whips and strings and not much else in our prints.

When we try to print rough (0.3mm), layers eventually don't stick together and we get a few layers of unbound strings of filament before complete failure.

0.2 mm works OK, although we tend to get strings of filament when the nozzle moves across a gap and our surface textures on top and bottom seem to be a bit rougher than what they were when the bot was fresh.

Any suggestions?

Thanks!