Results 1 to 4 of 4
Threaded View
-
04-02-2015, 11:57 AM #1
- Join Date
- Jan 2015
- Posts
- 2
Printrboard - can't move above z125
I'm using a Printrboard, and for some reason it won't go above z125. Mechanically, there is no issue, but it stops at z125 if you tell it to go higher than that, and it ignores any commands to move the head any higher.
Is there a firmware setting I need to change or something? The board came pre-configured.
Printed Model of Motor Cooling Fan...
Today, 02:07 PM in General 3D Printing Discussion