Results 1 to 5 of 5
Thread: Disaster! A plastic mess
Threaded View
-
03-17-2015, 10:12 AM #1
Disaster! A plastic mess
Well I kicked off a print and went to bed. The first layer was fine but something didn't seem right with the filament that was going down where the supports are supposed to be located. Woke up the next morning to find an unholy mess. The 80 gram part was just a few layers and the rest was gooped up in a ball all around the extruder. In the effort to free the machine I ended up destroying the wiring on the heating element. I have ordered new parts from China and hopefully that will get my machine back up and running.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion