Results 1 to 4 of 4
Threaded View
-
03-10-2015, 08:31 PM #1
- Join Date
- Mar 2015
- Posts
- 1
Belt slipping on FF Pro, any suggestions to fix this?
Hello
I have a recurring problem on a Flashforge pro and was wondering if anyone has had similar issues and how they fixed it
http://i.imgur.com/o08aXMx.jpg
http://i.imgur.com/3sIZdlM.jpg
http://i.imgur.com/ycBq9Q3.jpg
I think this little plastic piece of mine is warped because no matter how hard I screw it down, the belt always slips out to the left after a few hours printing.
I want to fix this by using super-glue to hold the belt to this plastic part, but if this doesnt work, I am going to ruin the part. I think I need a new one of these little plastic pieces but I dont know if you can even buy them. Is there any fix I can do to make sure the belt stops slipping out? maybe some kind of thin pad between the belt and the clip.
Maybe I just need a new belt? I dont know, I am willing to try a lot of things to fix this. Thanks for any advice people can give.Last edited by someguy; 03-10-2015 at 08:44 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion