Hi and thanks for reading my thread!
So I'm having some issues printing Taulman Bridge Nylon. The extruder seems to be having issues feeding the nylon, it has a brief moment when its feeding then slips on the nylon (rinse and repeat) When I received the filament it was damp (steam coming out from hotend, cracks and pops.etc) I have dried the filament out and those issues are gone. My printer prints PLA and ABS like a champ. So why this nylon is causing so much trouble has got me stumped. The filament measures 1.76~1.78mm so its a fraction on the large size. Not that I would expect that to cause the issue?

What I've tried so far:

Adjust idler lose
Adjust idler tight
Made a tiny adjustment to align hobbed bolt perfectly
Raised and lowered printing temp (235~255c)


My Setup:

Custom build Reprap i3
Gregs Wades extruder
E3D V6 1.75mm hotend