Results 1 to 3 of 3
Thread: Pla curl 1st 20 layers
Threaded View
-
02-25-2015, 08:42 PM #1
- Join Date
- Feb 2015
- Posts
- 8
Pla curl 1st 20 layers
OK SO IM STUCK .. im getting slight pla distortion the 1st 20 or so layers using simply3d software. ive tried heat and no heat on bed , with a fan and without. different nozzle temps so on and so on.. basically its no lifting off the bed it just the layers are rough.. maybe rising above the inside layers a little then it smooths out and looks perfect. i have this with abs also. im using a creator pro dual .. only have this with circle stuff , square and other types are ok . ive used rafts and outlins no luck.. any tips plz?
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion