Saving G29 Bed Level Correction Matrix to EEPROM

[Roxy]

When you connect to the board, does it say "Using EEPROM values!" ? What does it say the Version is and the Stored Version are?

Here is the M503 from a firmware with out safe G29 to eeprom. It doesn't safe z at the present...not sure why....

The main line code from GetHub did not print out the value for the Z-Probe offset. So, this would imply (at least for this print out) that you are building an unmodified Configuration_Store.cpp file. I'm wondering if you are having problems getting Arduino to load and build the correct set of file? I've had problems with that in the past!