Results 1 to 10 of 40
Thread: swapping to glass bed
Threaded View
-
02-22-2015, 04:23 PM #13
- Join Date
- Dec 2014
- Posts
- 61
In my last post I was referring to the piece that goes onto the z axis than stevendm linked to in this thread. Even 3mm is alot to adjust the bed leveling screws for. Perhaps you could compensate with a z axis offset but I have a feeling that the home command ignores it. You can only put it in firmware if you will be using it all the time.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion