Results 1 to 10 of 40
Thread: swapping to glass bed
Threaded View
-
02-22-2015, 04:23 PM #13
- Join Date
- Dec 2014
- Posts
- 61
In my last post I was referring to the piece that goes onto the z axis than stevendm linked to in this thread. Even 3mm is alot to adjust the bed leveling screws for. Perhaps you could compensate with a z axis offset but I have a feeling that the home command ignores it. You can only put it in firmware if you will be using it all the time.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion