Results 1 to 10 of 11
Thread: Power Supply Woes
Threaded View
-
02-18-2015, 10:51 AM #1
Power Supply Woes
So I went to turn on my power supply switch (after no installation or wiring changes since I last printed) and my printer turned on for less than half a second then shut off and will not turn back on. It is slightly cold (55-60F) in the are the printer is located.
I have an 8" i3v with a ATX power supply. I quickly looked at the wiring connections and did not see an issue. I have yet to ring out my wiring system.
Before I do so:
1. Do these supplies have an internal glass fuse that I should check first?
2. Has this happened to anyone before?
Many thanks!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help