Results 1 to 2 of 2
Thread: Filament Stuck
Threaded View
-
02-16-2015, 01:21 PM #1
Filament Stuck
All,
I have been having some problems with a specific spool of material, eSun PETG. Each time I print with it, at some point during the print, the filament ceases feeding and winds up spewing out of the extruder.
I expect this is due to variations in the diameter of the filament in addition to the "slimness" of the Hexagon feeding tube, would that be a correct assessment of what is going on?
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion