Results 1 to 10 of 46
Thread: Heated Bed wiring meltdown
Threaded View
-
02-14-2015, 07:23 PM #1
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
Heated Bed wiring meltdown
I was getting a max temp error on my printer
When I investigated the cause I found out that the relay terminal block was slightly burnt and the wires coming from the heated bed that go into the Terminal block were melted together with the therm sensor.
The Therm sensor is dead and I need a new one. I tried splicing in a new wires but it will no longer produce a reading.
The relay switch also needs replacement as I can no longer open and close it
update : i ended up changing the terminal block with something similar from my local electronics store and replacing the thermal sensor with one from my 2nd hotend.
so im back down to one hotend.. for now
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help