Results 1 to 10 of 85
Thread: Simplify3D with FlashForge
Threaded View
-
02-10-2015, 12:18 PM #11
- Join Date
- Oct 2014
- Posts
- 441
Yeah I know, but I meant how you can set it so it print's out a nice flat layer at the top of the support, right before it starts printing on the support. To give it a nice bottom layer of your print that is going on the support. I was hoping for a way to do that with infill, as well. (Say 10% infill, but switch to 75% infill 1 or 2 layers before it starting printing the first bottom layer.)
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion