The ExtrusionBot team is taking on a new and promising Kickstarter campaign with their motorized filament recycler which can ‘crunch’ any material into uniform, fine pellets that then goes on finally to produce further quality 3D prints. The pelletizer works in tandem with ExtrusionBot filament extruding devices or as a standalone device. Filaments can be made to use for 3D printing from old, failed prints -- or even water bottles! Check out more about this recycling wonder in the full article: http://3dprint.com/42595/extrusionbot-cruncher-recycle/


Have you helped to back this project on Kickstarter. Would you have use for the Cruncher? Below is a photo of the ExtrusionBot process: