Results 1 to 10 of 255
Threaded View
-
02-02-2015, 11:53 AM #11
Thanks for jumping in, Todd. Thanks to Rob as well for the response that came in while I was editing.
Thanks for the feedback. I don't regret my MakerFarm choice a bit. It's a great way to go, especially as a learning experience. The community here is top notch. Along with superb customer support from MakerFarm, the level of support is hard to beat.
I've been considering adding a few components to the assembly out of the box so I can do it on first assembly rather than later, though indubitably I will have to do this in the future, anyway. I was considering the kysan motors as one such addition. Do you have any recommendations on parts to add to the initial build either due to increased quality, or difficulty in adding them at a later time?
On the Kysans, I can't say that they are a value added benefit on the newer kits. Older kits shipped with a different motor that didn't really fit the 12V printer application very well, with an issue that they ran extremely hot. That's the main reason why mine were replaced. Newer kits ship with more appropriate motors that don't run hot.Last edited by printbus; 02-02-2015 at 05:07 PM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion