Results 1 to 7 of 7
Threaded View
-
02-01-2015, 07:41 PM #1
- Join Date
- Jan 2015
- Posts
- 20
Corners sticking up (not curling off bed) issue
What can cause this? It doesnt seem to match any issues found here http://support.3dverkstan.se/article...shooting-guide This is using makerbot pla, no bed heat, 195 degrees, 80/100 feedrate.
Thanks
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion