Results 1 to 5 of 5
Thread: Quadcopter safety cage
Threaded View
-
01-28-2015, 06:54 AM #1
Quadcopter safety cage
I'm going to be printing out a quad eventually. I plan on using dual Arduino Nano's for the Flight and camera control. Yes, I plan on reinventing the wheel and programming everything from the ground up, because I want to, not because it is easy, but because it is hard.
And since there will be a learning curve for both me as a pilot, the flight control computer, and the autopilot, I need to have "training wheels" for it.
So Has anybody ever seen a giant plastic cage for quad copters to make it just bounce off stuff rather than crash? Initial stabilization tests will be done in a barn
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion