Diagnosis Help

[xernex]

I'm sure this has been covered over and over, but I really don't know how to find my answer. I don't know exactly what verbage to search for.

I'm getting prints that come out like this:






Printing with a Flashforge creator, Sailfin firmware, Makerbot PLA, 60C bed and I've tried a range from 210C to 195C and end up with just about the same issue, Printing at 40-55 MM with moves at 60-80 depending one which time I try. Smaller stuff I don't end up with this problem often, but certain prints just seem to bug out as they get larger.

Any help for a newb would be greatly appreciated.