Results 1 to 4 of 4
Thread: Oiling the Z axis screw
Threaded View
-
01-13-2015, 08:28 AM #1
Oiling the Z axis screw
I've noticed that there's one point, a little more than halfway down, where my platform is consistently producing a rubbing noise as it travels up and down the center screw. Any advice on lubricating this screw? I've got WD-40, lithium grease, etc, just curious if there are any thoughts on the best stuff to use in here.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion