Results 1 to 3 of 3
Threaded View
-
01-08-2015, 05:33 AM #1
info needed on setting up stepper motors
I keep hearing on youtube about people whom say the controller board needs to be adjusted. Something about the motors get too much voltage causing them to overheat.
So I would like to know about how to address this. I gather that the controller board has screws of some fashion near the plug for the stepper motor that will be adjusted. That is all I have for knowledge at this time. Please enlighten me.
No I dont have a printer yet, but will (I hope) in 60 days.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help